mysterious dense alloy


by alan-c
Tags: alloy, dense, metal, steel
alan-c
alan-c is offline
#1
Sep4-13, 04:01 PM
P: 4
I would like to identify a mysteriously dense metal I have in my possession. I bought a big box of engineering bits, along with a lathe, and found what I thought were High Speed Steel tool blanks which felt very heavy. I worked out the relative density and it is an amazing 16.97. The material is non-magnetic and grinds like silver steel (unhardened tool steel); I haven't tried machining with it. The closest element is Tantalum at 16.7 but it's not that because tantalum is soft.
The only marking on each piece is EDF 32851 and each piece is about 9 x 9 x 155mm.
Any ideas?
Phys.Org News Partner Engineering news on Phys.org
PsiKick's batteryless sensors poised for coming 'Internet of things'
Researcher launches successful tech start-up to help the blind
Researchers propose network-based evaluation tool to assess relief operations feasibility
phyzguy
phyzguy is offline
#2
Sep4-13, 04:19 PM
P: 2,068
Could it be tungsten carbide (density 15.6)? It is often used for drill bits.
alan-c
alan-c is offline
#3
Sep4-13, 04:46 PM
P: 4
That was quick- and I never thought of TC. It's not though because it can be filed, although it is quite hard. It appears to be cast then ground to clean up, but not precision ground; this might help as a clue.

eigenperson
eigenperson is offline
#4
Sep4-13, 06:39 PM
P: 131

mysterious dense alloy


It basically has to be a tungsten alloy -- any other metal that dense is either too expensive and/or poisonous. So unless someone made a set of platinum drill bits, in which case you are pretty lucky, it's probably one of these, or something like them.
alan-c
alan-c is offline
#5
Sep5-13, 07:50 AM
P: 4
Fantastic! I spent hours searching without finding that. This seems very likely. In the link you provided, their rd17 material is made for boring bars where it's stiffness and high mass reduce chatter -vibration which leaves poor surface finish- when machining deep holes on a lathe. It would explain why this material turned up in a box of assorted engineering bits.
One day I'll get around to trying it out; when I do I'll report back.
rollingstein
rollingstein is offline
#6
Sep18-13, 03:35 AM
P: 305
Can't be depleted uranium can it? ;)
alan-c
alan-c is offline
#7
Sep18-13, 09:56 AM
P: 4
I'm not encased in a green glow so I'll stick with the tungsten alloy story.


Register to reply

Related Discussions
Show that f(E) is dense in f(X) if E is dense in X Calculus & Beyond Homework 1
Show that the preimage of dense set is dense? Topology and Analysis 2
Alloy compounds vs alloy solid solutions? Chemistry 1
Aluminum alloy Grains, Which alloy is it? Materials & Chemical Engineering 1
What is wrong with this picture? Brain Teasers 11