Register to reply

Gear reduction

by cbp5029
Tags: gear, reduction
Share this thread:
cbp5029
#1
Jun12-14, 10:03 AM
P: 1
I have a 3hp motor, with a torque of 110.85 lb*in. a gear box with a max torque of 6286 lb*in.

gear box ratio is 57.64:1

I have gears attached to the gearbox shaft with a gear reduction of 3.375:1.

My new gear ratio should be 194.53:1 right?....

which would make my output torque approx. 21,500 lb*in...?

just checking
Phys.Org News Partner Engineering news on Phys.org
Amazon worker piloted drone around Space Needle
Five next-generation technologies for positioning, navigation and timing
Hoverbike drone project for air transport takes off
Travis_King
#2
Jun12-14, 10:57 AM
P: 815
Are you sure about your motor's torque? I ask because you list the gearbox's max torque (is that it's rated torque) at a value that is lower than the motor torque*reduction.

Also, understand that AC motors (if that's what you are using) are not constant torque machines. They have torque curves, and starting/peak torque can be upwards of 200% (in some cases much higher) of rated torque.

I'd verify you've got the right parts for the application.

As per your question, yes, if you have a gearbox with a 57.64:1 ratio and the output of that is subjected to another 3.375:1 reduction, you will have a 194.53:1 reduction and theoretical torque of 21,500 in*lb (depending on efficiency of the powertrain).


Register to reply

Related Discussions
A mechanics problem involving a large gear and a small gear Engineering, Comp Sci, & Technology Homework 1
Gear reduction question Mechanical Engineering 6
Gear mechanism and wheel arrangement for reduction of fuel consumption Mechanical Engineering 1
Double Reduction Gear Mechanical Engineering 7
Number of gear teeth in two-stage reduction gears Mechanical Engineering 11