- #1
blakej
- 13
- 0
Hi,
I'm doing a design which requires a face seal with internal gas pressure of 3000 psig. An elastomer face seal at that pressure may run into some issues. The threaded connection between the parts that retain the seal is small and the female thread is alum which will strip under high torque which may make using a metal seal challenging. Any material suggestions I should check out for this face seal?
Thanks!
Blake J
I'm doing a design which requires a face seal with internal gas pressure of 3000 psig. An elastomer face seal at that pressure may run into some issues. The threaded connection between the parts that retain the seal is small and the female thread is alum which will strip under high torque which may make using a metal seal challenging. Any material suggestions I should check out for this face seal?
Thanks!
Blake J