Interstate natural gas pipelines & valves


by rollingstein
Tags: interstate, natural, pipelines, valves
rollingstein
rollingstein is offline
#1
Oct9-13, 12:00 PM
P: 305
Often there's these stories on TV about someone accidentally damaging a large diameter natural gas pipeline while digging a ditch etc. and then a huge raging fire.

What I'm wondering about is how frequently are shutoff valves installed on these lines. My intuition says ~30 miles apart at most. If so, how long does 30 miles worth of piped gas take to burn itself out. I'm just trying to get a rough estimate here.

In a flowing interstate pipe I think gas velocity is somewhere about 20 m/sec? Though not sure how to estimate the burn time after the valve is shut off.
Phys.Org News Partner Engineering news on Phys.org
Researchers propose network-based evaluation tool to assess relief operations feasibility
Large streams of data warn cars, banks and oil drillers
Engineering student developing traffic forecasts
AlephZero
AlephZero is offline
#2
Oct9-13, 01:22 PM
Engineering
Sci Advisor
HW Helper
Thanks
P: 6,342
This http://www.phmsa.dot.gov/staticfiles...cv_rpt.fnl.pdf page 6 gives "10 minutes for a 5 mile stretch of 24 inch pipeline if the failure is near one end".

Page 15 makes the comment that "of 81 incidents studied, virtually all fatalities and injuries occurred within the first 3 minutes".

Page 16 gives a requirement of shutoff valves every 8 miles for some class of pipeline (I've no idea what the jargon means).

Another consideration is the length of time it takes to close any shutoff valves - estimated at 10 minutes for remote controlled valves and 30 to 40 minutes for manual valves. The general conclusion seems to be that RC values were technically feasible but don't have any economic benefit.
SteamKing
SteamKing is offline
#3
Oct9-13, 01:46 PM
HW Helper
Thanks
P: 5,531
The term 'class' refers to the number of inhabited buildings within a certain distance of a gas pipeline. A Class 1 location is offshore, and presumably there are no inhabited buildings nearby. The other Class designations are defined in the Code of Federal Regulations, 49 CFR 192.5.


Register to reply

Related Discussions
URGENT PLEASE HELP! what kind of pipelines are used in different areas Materials & Chemical Engineering 4
Ways to detect water theft from pipelines Engineering, Comp Sci, & Technology Homework 0
Pressure difference in two pipelines Introductory Physics Homework 1
drug development pipelines for new antibiotics Medical Sciences 2
Interstate Highway System Turns 50 General Discussion 7