Register to reply 
Heat Transfer through Evaporators 
Share this thread: 
#1
Aug2513, 06:39 AM

P: 50

Dear all,
I am a bit stuck trying to find out how heat is transfered through an evaporator in a refrigerator. I was using Newton's law of cooling before I realised there are more complexities in the equation as the refrigerant is in a mixture of saturated liquid and saturated gas in the evaporator. Newton's Law of cooling (heat transfer from a solid surface to a fluid): QL=UL*AL*LMTD where QL= heat transfer UL= overal heat transfer coefficient AL= external surface area of the evaporator LMTD= log mean temp different over the evaporator tube. i.e. The average temperature difference between the solid surface and the fluid (air in this case) across the evaporator inlet and outlet. My Question Is Newton's Law of cooling applied to refrigerator evaporators and/or condensers with this equation, for a simplified calculation? Or would the results be so far from correct that calculations must always take into consideration the boiling and condensing of the refrigerant? 


#2
Aug2613, 01:03 PM

P: 51

The heat convection equation will provide a good calculation of the heat transfer but it requires a knowledge of LMTD meaning you need to know the hot fluid inlet temp, hot fluid outlet temp, cold fluid inlet temp and cold fluid outlet temp. You also need to be able to calculate U, which requires the use of empirical correlations (for condensers anyway, not sure about evaporators). It can be difficult to accurately calculate all these terms.
If you are simply looking for a good approximation of the heat transfer, an energy rate equation (enthalpy eqn) should suffice. In the case of an evaporator, the working fluid (refrigerant) acts as if it has an infinite specific heat capacity and can be assumed as isothermal. When adding energy to this fluid, the enthalpy of vaporization is the major contributor and sensible heat can probably be neglected, provided the liquid is relatively saturated at inlet and outlet (isnt too subcooled or superheated) If this is the case, the energy eqn simplifies to the heat/energy added to the fluid; [itex]\dot{Q}[/itex]=[itex]\dot{m}[/itex][itex]\Delta[/itex]hfg All you need to know is the flow rate of the refrigerant and the change in enthalpy from inlet to outlet (get this in thermo tables for whatever fluid you are looking at). 


Register to reply 
Related Discussions  
Overal heat transfer coefficient: Refrigeration Heat Exchanger  Engineering, Comp Sci, & Technology Homework  3  
Heat Transfer: Calculating heat transfer rate?  Engineering, Comp Sci, & Technology Homework  4  
How long to melt the ice(heat, heat transfer, latent heat)  Introductory Physics Homework  3  
Equation for heat transfer and output of heat from a thermal storage unit  Classical Physics  0  
Design calculator for Condensers, evaporators, heat pumps  General Engineering  5 