Register to reply 
Bird eyes  and how to model them!by Samuelsart
Tags: bird, discrimination model, eyes, jnds, model, modelling or theory, visual perception, weber fraction 
Share this thread: 
#1
Oct1513, 09:13 AM

P: 18

OK so I am not sure if this should be on a physics forum, a maths forum or a biology forum. All I know is I am stuck.
A little back ground: Researchers have modelled how various animals can see depending on their visual sensor cells, namely cones (colours vision) and rods (luminance). What I understand is that I am supposed to use my light spectrophotometer reflectance data and run a discrimination model to get JNDs (Just Noticeable Differences), the measurements used to discriminate weather or not a bird can tell the difference between either colours (using the models used for comes) or luminance (rod models). This is usually based on a discrimination factor (often Weber fraction 0.05), and relative proportions of vision cone types in predator's retina. The results from discrimination model are JND's. As far as I understand Vorobyev & Osorio 1998, Osorio & Vorobyev 2005 (Attached :)) are probably the most influential papers defining foundations of vision modelling. But seriously, having read them through approximately 4 or 5 times over the last 3 weeks I am no further forward in actually opening excel (or the software needed) and actually making a model. I don't even know if 'running a model' is metaphoric or I need to open R or similar and run something!!! Any help would be greatly appreciated. Kind Regards Sam 


#2
Oct1513, 09:33 AM

Homework
Sci Advisor
HW Helper
Thanks
P: 12,974

Start with the end in mind: what is your model supposed to be telling you?
What will it be useful for  specifically? What is your level of physics and math here? Note: excell is unlikely be up to the task. 


#3
Oct1513, 09:59 AM

P: 18

The model is supposed to tell me what the JNDs are for my two treatments, from this I can tell if a bird can discriminate between two visual signals.
It will be and has been used for putting spectrophotometer data into an ecologically relative context. My personal level? not great but I need to complete this analysis so I really have no choice but to figure it out. I know people who are less mathematically literate than I am have completed this analysis and I am finding it incredibly frustrating. Equations scare, I will not lie. I do however want to learn how to solve them..and not be scared any more!! 


#4
Oct1513, 10:00 AM

P: 18

Bird eyes  and how to model them!
Point taken on excel!!



#5
Oct1513, 05:14 PM

Homework
Sci Advisor
HW Helper
Thanks
P: 12,974

Have you done this kind of modelling before  say for different sorts of eyes?
i.e. what is the holdup? Where do you get stuck? 


#6
Oct1513, 05:23 PM

P: 18

Hi,
No, I have not done this before or anything like it. I do not have a clue where to start! I have my Photospec. data that is it. I just don't get the concept of running a model or where to get the numbers to put into an said model. Just imagine someone with zero confidence in maths and equations. But with a health, almost unhealthy appetite to learn! 


#7
Oct1513, 05:48 PM

Mentor
P: 41,109

Is this for some kind of research project? What is the end goal? How did you end up with this project, if you don't have the modeling experience yet?



#8
Oct1513, 06:42 PM

P: 18

Fair question!
I am a PhD. student learning my trade so to speak! I guess as in all research, the end goal is to publish! I am a biologist, working with iridescent insects (see some other posts). I would like to model my light spectro. data with their potential predators! i.e. birds and specifically bluetits as most research on avian visual modelling has been done with this species. I was not being vague on purpose, I just didn't think the information was needed. Apologies, I have no mysterious motives. Kind Regards S. 


#9
Oct1513, 08:08 PM

Homework
Sci Advisor
HW Helper
Thanks
P: 12,974

So you know how eyes work and you have some standard model for rods and cones?
iirc different species of bird have different vision characteristics. 


#10
Oct1613, 03:37 AM

P: 18

Yes, there is a standard model for blue tits (and various other species) for both rods and cones. The birds have 4 cone types, as ours plus U.V. sensitive. The models are in the attached papers!



#12
Oct1613, 06:34 AM

P: 18

How do I implement the (any) model?
Where do I start to understand it enough to get out what I want? What is a discrimination model? 


#13
Oct1613, 07:19 AM

Homework
Sci Advisor
HW Helper
Thanks
P: 12,974

Oh I see  you have the model but you have no idea what it means, and your math is not up to the task.
It's not trivial. You will need to bring yourself up to speed in a new field and get familiar with the kid of math needed. You need to look up the citations in the paper you get your model from to start with  explore the literature. This is part of the PhD work you need to learn  there is no royal road here. It's also much bigger than what we can deal with in these forums. Since you know others who have used these models, why not ask them for pointers? Networing and consultation are an important part of the scientific process. You also need a clearer idea of what the end result is supposed to be. Per your posts: "running the model" is, indeed, a metaphor for using the equations  the math  that is used to describe the model. You need to implement the model equations in some way that makes sense for your desired end result. The authors should have provided examples or references to examples. You should have experience with other examples of mathematical models  like predatorprey models, or cell growth models, stuff like that, in your undergrad work? 


Register to reply 
Related Discussions  
Bird 1, LHC 0  High Energy, Nuclear, Particle Physics  2  
What bird is this?  General Discussion  28  
1200 mph bird?  General Discussion  3  
Bird Flu  going pandemic?  Current Events  59  
Bird Physics  General Physics  5 