- #1
will0057
- 1
- 0
Hi - sorry I'm not an engineer just desperate!
I want to remove pitting and marking in a shotgun bore and am having problems finding a tool which will do this in the firearms sector - and if I do I am sure it will be at a premium price - removing a small amount ie less than a thou of the internal diameter of a bore and polishing must be a fairly common requirement in engineering - does anyone know of a cheap portable tool which will do this (as opposed to factory honing) I want something I can put on a drill and spin in the bore - have tried brake honing stones but really need something which will apply equal pressure (or nearly) at all surfaces of the bore, the nearest I can get so far is to try rig up an expanding mandrel - is their anything commercially available?
Thanks
Will
I want to remove pitting and marking in a shotgun bore and am having problems finding a tool which will do this in the firearms sector - and if I do I am sure it will be at a premium price - removing a small amount ie less than a thou of the internal diameter of a bore and polishing must be a fairly common requirement in engineering - does anyone know of a cheap portable tool which will do this (as opposed to factory honing) I want something I can put on a drill and spin in the bore - have tried brake honing stones but really need something which will apply equal pressure (or nearly) at all surfaces of the bore, the nearest I can get so far is to try rig up an expanding mandrel - is their anything commercially available?
Thanks
Will