integrating op amp question

by Cantstandit
Tags: integrating
Cantstandit is offline
Mar5-13, 03:18 PM
P: 30
I'm having problem understanding the output of the integrating op amp.
(hope you can see that, I can't see it on my preview)

The blue line is input, orange is output. So if it's supposed to integrate, surely output signal has a wrong sign, doesn't it? If the integral is the area under the square signal, there should be linear increase when the signal is positive and linear decrease when it's negative, yet it's the other way around, why? I'd thought it was because my voltage had been applied to the inverting input of the op-amp, but even when I flipped it, it stays the same...
Phys.Org News Partner Engineering news on
SensaBubble: It's a bubble, but not as we know it (w/ video)
WSU innovation improves drowsy driver detection
Faster computation of electromagnetic interference on an electronic circuit board
jim hardy
jim hardy is online now
Mar5-13, 07:03 PM
Sci Advisor
jim hardy's Avatar
P: 3,149
Remember you have an inverting amplifier there.
The opamp will hold its inputs equal, and +input is at zero.
Therefore whatever current is pushed into summing junction through R1 must get pulled back out through C1&R2,,,,
,,,so an input to output reversal of polarity is nessary.

After the initial transient (power up i presume?) , output looks like it moves in right direction.

Register to reply

Related Discussions
Integrating factor question Calculus & Beyond Homework 0
ODE question - Integrating factor Calculus & Beyond Homework 2
Question regarding integrating (int(1/u)) Calculus & Beyond Homework 1
Question integrating |f(z)||dz| over a contour C Calculus & Beyond Homework 4
Quick integrating question....(part of a series question) Calculus & Beyond Homework 3