# Sequence components in fault study

 P: 9 Hi all! I am currently learning fault study in power systems. To my understanding- In any network (symmetrical or unsymmetrical) , there would be 3 components- positive sequence component, negative sequence component and zero sequence component. Question: For generators and transformers , would synchronous reactance mean/signify its positive sequence reactance? It would be very helpful if an explanation about the definition and differentiation among: subtransient, transient and synchronous reactance be provided. A prompt reply from any user is much appreciated. :)
 P: 9 btw, please and thank you!
 PF Gold P: 375 Yes the synchronous reactance is the positive sequence reactance. It is only useful directly when modelling lines, because generators and transformers are not modelled (usually) by a lumped reactance. Good treatment is given in 'Power system analysis' by Grainger & Stevenson. I could be corrected but I think page 460 describes how 3 phase transformers are modelled for fault conditions based on transformer type. For synch. Generators without grounded neutral, the pos. and neg. sequence diagrams can be modeled by the synch reactances of the machine. If the neutral is ungrounded, the zero sequence diagram is opened at that point, too. If the neutral is grounded through a a reactance, the zero sequence diagram has to be analyzed with 3 x the grounding reactance in series with the machine reactance. It's a lot to describe briefly, see Grainger.
 P: 51 Sequence components in fault study As per IEC 60909-0: usually the positive-sequence reactance and negative-sequence reactance are the same: for synchronous machine X2=~X1=X”d [saturated is less then unsaturated]. If X”d<>X”q then X2[negative-sequence]=(X”d+X”q)/2 For 2 windings transformers X1=X2=XT [at the main position of the on-load tapchanger] XT=sqrt(ZT^2-RT^2) ZT=uk%/100*Vrat^2/Strf uk% =short-circuit voltage of transformer Vrat=Rated voltage Strf=rated apparent power of the transformer.
P: 9
 Quote by FOIWATER Yes the synchronous reactance is the positive sequence reactance. It is only useful directly when modelling lines, because generators and transformers are not modelled (usually) by a lumped reactance. Good treatment is given in 'Power system analysis' by Grainger & Stevenson. I could be corrected but I think page 460 describes how 3 phase transformers are modelled for fault conditions based on transformer type. For synch. Generators without grounded neutral, the pos. and neg. sequence diagrams can be modeled by the synch reactances of the machine. If the neutral is ungrounded, the zero sequence diagram is opened at that point, too. If the neutral is grounded through a a reactance, the zero sequence diagram has to be analyzed with 3 x the grounding reactance in series with the machine reactance. It's a lot to describe briefly, see Grainger.
thank you very much, foiwater!
P: 9
 Quote by Babadag As per IEC 60909-0: usually the positive-sequence reactance and negative-sequence reactance are the same: for synchronous machine X2=~X1=X”d [saturated is less then unsaturated]. If X”d<>X”q then X2[negative-sequence]=(X”d+X”q)/2 For 2 windings transformers X1=X2=XT [at the main position of the on-load tapchanger] XT=sqrt(ZT^2-RT^2) ZT=uk%/100*Vrat^2/Strf uk% =short-circuit voltage of transformer Vrat=Rated voltage Strf=rated apparent power of the transformer.