Register to reply

NACA 0012 lift and drag coefficient.

by maomao39
Tags: 0012, coefficient, drag, lift, naca
Share this thread:
Mar28-12, 07:40 PM
P: 12
I am running ANSYS fluent simulation flow over naca 0012 airfoil.
So far the lift coefficient is similar with the published papers.
The problem is drag coefficient is different so much in term of value compared to published papers.
I have check my mesh quality and boundary condition, it shows no problem.
Any idea why drag coefficient is different ???
Phys.Org News Partner Science news on
World's largest solar boat on Greek prehistoric mission
Google searches hold key to future market crashes
Mineral magic? Common mineral capable of making and breaking bonds
Mar29-12, 11:05 PM
P: 101
I don't know if it's the case, but I do know that calculating drag has always been the bane of CFD.
Mar31-12, 03:59 PM
P: 286
To get the drag correctly, you need to resolve the sub-layer. Your y+ value needs to be around y+=1.0.
Also, drag calculations are sensitive to the downstream vortices and the pressure profile in the far field. You need to accurately capture the wake of the airfoil for at least 10 cord lengths, and the distance to the boundary of the far field needs to be be about the same length. So basically, there is at least 10 cord lengths of mesh in all directions around the airfoil.

Also, the predictions depend a lot on the turbulence model used.

You can still be off by 10-20% though because of the bad prediction of the transition point where the laminar boundary layer becomes turbulent.

May12-12, 06:02 AM
P: 5
NACA 0012 lift and drag coefficient.

From the literature I've seen on ANSYS, at least 25 chord lengths were suggested.

I've done around 10 and had problems before.
Jun6-12, 11:37 AM
P: 1
I just have done the experiment with NACA0012 finding drag and lift.
I had same problem about the amount of drag force.
but I think there are some interference. for example... pitot's effect, boundary effect...
sorry for weak English.

Register to reply

Related Discussions
Points of action for thrust and drag forces and lift-drag ratio Aerospace Engineering 1
Suitability of the NACA 0012 for aircrafts Aerospace Engineering 3
How does the pressure difference over a NACA 0012 affects its characteristics? Aerospace Engineering 1
Lift and Drag coefficient equation in terms of pressure Mechanical Engineering 3
Fluid Mechanics - Drag coefficient and Pressure coefficient Mechanical Engineering 1