- #1
mat337d
- 16
- 0
I have just purchased some thermistors
(NTC 50,100,250 ohms). I want to wire it with a led.
so it will controll the leds light output with changing temp. I have already tried both series and parrallel configurations. the series confguration does not work at all. In parrallel configuration the thermsistor gets
very hot and the led dimms till it goes out. Am I doing somthing wrong? Is their a special way to wire
thermistors? thanks
power supply 9v 300ma
(NTC 50,100,250 ohms). I want to wire it with a led.
so it will controll the leds light output with changing temp. I have already tried both series and parrallel configurations. the series confguration does not work at all. In parrallel configuration the thermsistor gets
very hot and the led dimms till it goes out. Am I doing somthing wrong? Is their a special way to wire
thermistors? thanks
power supply 9v 300ma
Last edited: