Flat plate in tension test

[grigor1812]

I was wondering what equiptment would be best suited to using multiple strian gauges on specific points on a flat steel plate with a central hole in tension. What is the simplest experimental set-up to obtain reading from the gauges?

Any points/links would be appreciated.

 

[MalliCk]

may be,or more likely,an exteniometer/or a deflectometer

 

[oswaler]

I would recommend using a universal testing machine equipped with a tensile grip fixture to perform the flat plate tension test. This type of equipment is specifically designed to apply controlled tension forces to materials and can accommodate multiple strain gauges at specific points on the plate. Additionally, the central hole in the plate can be clamped securely in the grip fixture to ensure uniform loading.

To obtain readings from the strain gauges, a data acquisition system can be used. This system will record and analyze the data from the gauges, providing accurate and precise measurements of the strain at each point on the plate. The simplest experimental set-up would involve attaching the strain gauges to the plate using a suitable adhesive and then connecting them to the data acquisition system.

I would also recommend consulting relevant literature or contacting manufacturers of strain gauges and testing equipment for further guidance and specific product recommendations. Proper calibration and careful handling of the equipment and strain gauges are crucial for obtaining reliable and accurate results. I hope this information helps and good luck with your experiment.