Strength reduction factors for welded edge joints


by fpdlskf
Tags: edge, factors, joints, reduction, strength, welded
fpdlskf
fpdlskf is offline
#1
Feb22-12, 09:29 PM
P: 8
I've looked everywhere and can't seem to find any information.

Would someone be kind enough to point me to some literature?
Phys.Org News Partner Engineering news on Phys.org
Fiber-optic microscope will help physicians detect cancer, diseases at early stages
Wind tunnel tests support improved aerodynamic design of B61-12 bomb
Smart sensor technology to combat indoor air pollution
Astronuc
Astronuc is offline
#2
Feb22-12, 09:57 PM
Admin
Astronuc's Avatar
P: 21,625
I think ASME, SAE and AWS would have specific standards.

There may be examples in this publication - http://www.metalwebnews.org/ftp/weld...-TI-809-26.pdf For example, see - STRENGTH REDUCTION EFFECTS AND OTHER CONCERNS WHEN WELDING UNDER LOAD

It's usually material and geometry dependent, but then there are environmental effects as well.

By welded edge, is one thinking of lap joints or butt joints?
fpdlskf
fpdlskf is offline
#3
Feb22-12, 10:16 PM
P: 8
Thanks for the reply.

Quote Quote by Astronuc View Post
By welded edge, is one thinking of lap joints or butt joints?
Neither. By edge joint I mean something like this..



Register to reply

Related Discussions
How to calculate strength of welds (welded joints)? Materials & Chemical Engineering 1
Why does the LPG cylinder has to be two parts welded together Aerospace Engineering 3
Factors that affect peel strength of tape adhesives Mechanical Engineering 0
Factors affecting signal strength. Electrical Engineering 6
Equivalent stress in a welded part Mechanical Engineering 3