Register to reply

Volt-second balance in DC converter coil design?

by hobbs125
Tags: balance, coil, converter, design, voltsecond
Share this thread:
hobbs125
#1
Feb22-13, 05:38 PM
P: 104
Hi everyone,

I working on the design of a small DC converter coil with a step up ratio of about 1:8.
I have been told I need to ensure I maintain a volt-second balance on all windings but I'm not exactly sure what was meant by that.

Do I just need to make sure each winding stays below saturation?

Thanks in advance!
Phys.Org News Partner Engineering news on Phys.org
DIY glove-based tutor indicates muscle-memory potential
Tricorder XPRIZE: 10 teams advance in global competition to develop consumer-focused diagnostic device
Study shows local seismic isolation and damping methods provide optimal protection for essential computing equipment

Register to reply

Related Discussions
What is this coil inside this AC to DC power converter? Electrical Engineering 4
DC - DC (boost) Converter Design Electrical Engineering 12
Need help with boost converter design Electrical Engineering 6
How to design a boost converter from 5v to 24v Electrical Engineering 16
Design a boost converter Engineering, Comp Sci, & Technology Homework 1