- #1
JamesJames
- 205
- 0
I am just getting started on LateX and here is what I have done
I typed in this trial file and saved it. Then at the prompt typed latex myfile where myfile is the name of the file...
\documentclass{article}
\begin{document}
psi\mapsto 1/2\,m{\omega}^{2}{x}^{2}\psi
\end{document}
A whole bunch of stuff came up and then it said "No output pages" and then "Transcript copied to myfile.log."
I am using XP.
What do I have to do to see the following output in a file?
[tex]
H:=psi\mapsto \frac{1}{2}\,m{\omega}^{2}{x}^{2}\psi
[/tex]
I am getting the hang of the coding..
[tex]
shro:=-\frac{1}{2}\,{\frac {{h}^{2}{\frac {d^{2}}{d{x}^{2}}}\psi \left( x \right) }{
m}}+\frac{1}{2}\,m{\omega}^{2}{x}^{2}\psi \left( x \right) =E\psi \left( x
\right)
[/tex]
[tex]
-\frac{h \omega\}{2}\,left( {\frac {d^{2}}{d{y}^{2}}}\psi \left( y \right)
\right) +\frac{1}{2}\,\omega\,{y}^{2}h\psi \left( y \right) =E\psi
\left( y \right)
[/tex]
James
I typed in this trial file and saved it. Then at the prompt typed latex myfile where myfile is the name of the file...
\documentclass{article}
\begin{document}
psi\mapsto 1/2\,m{\omega}^{2}{x}^{2}\psi
\end{document}
A whole bunch of stuff came up and then it said "No output pages" and then "Transcript copied to myfile.log."
I am using XP.
What do I have to do to see the following output in a file?
[tex]
H:=psi\mapsto \frac{1}{2}\,m{\omega}^{2}{x}^{2}\psi
[/tex]
I am getting the hang of the coding..
[tex]
shro:=-\frac{1}{2}\,{\frac {{h}^{2}{\frac {d^{2}}{d{x}^{2}}}\psi \left( x \right) }{
m}}+\frac{1}{2}\,m{\omega}^{2}{x}^{2}\psi \left( x \right) =E\psi \left( x
\right)
[/tex]
[tex]
-\frac{h \omega\}{2}\,left( {\frac {d^{2}}{d{y}^{2}}}\psi \left( y \right)
\right) +\frac{1}{2}\,\omega\,{y}^{2}h\psi \left( y \right) =E\psi
\left( y \right)
[/tex]
James
Last edited: