- #1
ank_gl
- 741
- 0
just after i point the flexlm license finder to the license, i get this message
"Error in saving configuration settings: for further information, refer to the flexlm end user manual, available at "www.globetrotter.com""
then gambit starts and i can make the geometry i want to make. after specifying boundary types, when i go to export the mesh file, this error comes up
Error: continuum or boundary type specified on entity edge.4 is invalid for fluent6
Error: continuum or boundary type specified on entity edge.2 is invalid for fluent6
earlier neither that config error came up, nor this invalidity error came, i am confused on what to do. recently i reinstalled windows. what am i supposed to do to fix up this mess??
"Error in saving configuration settings: for further information, refer to the flexlm end user manual, available at "www.globetrotter.com""
then gambit starts and i can make the geometry i want to make. after specifying boundary types, when i go to export the mesh file, this error comes up
Error: continuum or boundary type specified on entity edge.4 is invalid for fluent6
Error: continuum or boundary type specified on entity edge.2 is invalid for fluent6
earlier neither that config error came up, nor this invalidity error came, i am confused on what to do. recently i reinstalled windows. what am i supposed to do to fix up this mess??