Register to reply 
How to calculate the resonance frequency of this circuit? 
Share this thread: 
#1
Dec2313, 01:59 AM

P: 2

Hi,
Need help with this circuit. I am task to find out the resonance frequency of this circuit. R=30 ohms L=20mH C1=2uF C2=3uF If it is just R,L and C1 and I easily calculate the resonance frequency by applying the formula f=1/2∏√LC Now I have another capacitance C2 parallel to this original RLC1, how do I calculate the resonance? How does this C2 affect the resonance? Any help is appreciated. Thanks. 


#2
Dec2313, 02:42 AM

P: 852

The two capacitors are in series so you can find the equivalent capacitance by [itex] \frac{1}{C}=\frac{1}{C_1}+\frac{1}{C_2} [/itex]. Now you have only one capacitor!



#3
Dec2313, 03:05 AM

P: 2

C2 is parallel to the whole of the R,L,C1.
I can just add up the Capacitance component with this formula? 1/C = 1/C1 +1/C2 


#4
Dec2313, 03:25 AM

P: 852

How to calculate the resonance frequency of this circuit?
The way I see it,the two capacitors are in series...but if you have problem with this,I can suggest another approach.You can consider all elements as impedance(check here) and because impedances,like resistors,are simply added when in series,you can add the corresponding impedances of each of the elements.Then you can differentiate with respect to frequency and set it equal to zero.
EDIT:I should note that all elements are in series in this circuit.Those circles coming out of the two ends of the second capacitor are probably connected to a voltmeter which is ideally an infiniteresistance element and so no current goes through that branch and so all the current just goes through the second capacitor and so it becomes series with other elements! 


#5
Dec2313, 04:30 AM

Sci Advisor
Thanks
PF Gold
P: 12,171




#6
Dec2313, 11:42 AM

Engineering
Sci Advisor
HW Helper
Thanks
P: 7,169

It's much easier to combine C1 and C2 in series first. 


#7
Dec2313, 11:47 AM

Sci Advisor
Thanks
PF Gold
P: 12,171

People are obsessed with classifying a circuit as either parallel or series. In this case (as usual), it makes no difference what you call it. The sums give you the same answer for resonant frequency wherever you connect your test probe. Look at any simulation. They don't give you a special button to press to select Series or Parallel.



#8
Dec2613, 07:47 PM

Sci Advisor
P: 4,032

This circuit has two resonances which occur at slightly different frequencies.
The resistor has an effect on the shape of the resonances but can be ignored for the purpose of finding the frequencies. Redrawing the diagram may help explain this: In the top diagram the inductor is in parallel with the two capacitors in series and the feedpoint is at the junction of the two capacitors. At the resonant frequency, the input will see a high impedance. In the second diagram, the resonance is formed by the 2 uF capacitor in series with the inductor. The feedpoint will see a low impedance. You can apply the usual resonance formula to obtain these resonant frequencies. Note that the series resonant frequency is lower than the parallel resonant one because the capacitors are in series in the parallel one. LTSpice gives both resonances. 


#9
Dec2713, 06:15 AM

Sci Advisor
Thanks
PF Gold
P: 12,171

I don't think there is enough information in the very first circuit. The impedance of the source / detector is relevant. If a voltage source is connected to the input terminals then C2 becomes irrelevant and you will have an impedance minimum (current max) at the L and C1 resonance. If you drive the input terminals with a current source then there will be a resonance with L and (C1 series C2).
@vk6kro. What does LTSpice assume in your simulation? 


#10
Dec2713, 06:54 AM

Sci Advisor
P: 4,032

So a high impedance shows in the graph as a reduced current and vice versa. The 30 ohm resistor produces considerable damping and the resonance features are quite broad. However they are obvious. I guess posting the simulation here might be a bit too helpful, but I can PM it if you like. C2 does not affect the input voltage at the parallel resonant frequency, but it does affect the current, much like a power factor capacitor does. Were you affected by the big storm last week? 


#11
Dec2713, 07:11 AM

Sci Advisor
Thanks
PF Gold
P: 12,171

I believe that the results of simulations should always be used with great care. In fact, I would almost go so far as to say that you should only ever use a simulation if you could work out the answer for yourself if only you had the time and inclination. On their own, the bare results of a simulation don't necessarily 'prove' anything. I think the analytical way to approach to this very basic problem is more fruitful so, no thanks, to your offer of the simulation. I don't think the storm affected our house at all and the family all travelled here in periods between bouts of bad weather. How about you? 


#12
Dec2713, 07:42 AM

Sci Advisor
P: 4,032

I find LTSpice pretty accurate and certainly quicker than me on a calculator.
In this case the resonances are spoton the calculated frequencies. It is especially good when opposing effects are at work. I have used other programs where you have to know the answer to get a result from the simulation, but LTSpice is a seriously good program. Easy to use, too. I am not in the UK but managed to watch a UK sporting team getting demolished. Doing better today. 


#13
Dec2713, 07:51 AM

Sci Advisor
Thanks
PF Gold
P: 12,171

LTSpice isn an excellent package, I believe. It should give the same results as your calculator  I should hope so too! It's just that numerical solutions are only ever applicable to a particular problem and can allow you to miss the bigger picture and to get results without any serious understanding.
I don't watch much cricket (I assume that's what you refer too???) but it was somewhat galling, I have to admit. It's a bit late for them to be doing better now. We can hardly blame the Aussies for easing up a bit now they've made their point. 


#14
Dec2713, 08:05 AM

Sci Advisor
P: 4,032

It is frustrating to see that program pop up with an answer immediately when I have to battle through a page of simultaneous equations.
Yes that sporting team were pretty unlucky that hardly any of them got to show that they were better than they appeared. Nobody expects that to continue. 


Register to reply 
Related Discussions  
Resonance Frequency of Series LCL circuit  Electrical Engineering  1  
Best RLC circuit for Low Frequency underdamped resonance  Classical Physics  9  
RLC circuit and resonance frequency  Engineering, Comp Sci, & Technology Homework  5  
Calculate Resonance Frequency of a Molecule  General Physics  1  
Resonance frequency in an LCR circuit  Introductory Physics Homework  1 