Register to reply

Volt-second balance in DC converter coil design?

by hobbs125
Tags: balance, coil, converter, design, voltsecond
Share this thread:
hobbs125
#1
Feb22-13, 05:38 PM
P: 104
Hi everyone,

I working on the design of a small DC converter coil with a step up ratio of about 1:8.
I have been told I need to ensure I maintain a volt-second balance on all windings but I'm not exactly sure what was meant by that.

Do I just need to make sure each winding stays below saturation?

Thanks in advance!
Phys.Org News Partner Engineering news on Phys.org
Tricorder XPRIZE: 10 teams advance in global competition to develop consumer-focused diagnostic device
Study shows local seismic isolation and damping methods provide optimal protection for essential computing equipment
New filter technology uses inert gas to bore holes in high-quality steel

Register to reply

Related Discussions
What is this coil inside this AC to DC power converter? Electrical Engineering 4
DC - DC (boost) Converter Design Electrical Engineering 12
Need help with boost converter design Electrical Engineering 6
How to design a boost converter from 5v to 24v Electrical Engineering 16
Design a boost converter Engineering, Comp Sci, & Technology Homework 1