Register to reply

Mysterious dense alloy

by alan-c
Tags: alloy, dense, metal, steel
Share this thread:
Sep4-13, 04:01 PM
P: 4
I would like to identify a mysteriously dense metal I have in my possession. I bought a big box of engineering bits, along with a lathe, and found what I thought were High Speed Steel tool blanks which felt very heavy. I worked out the relative density and it is an amazing 16.97. The material is non-magnetic and grinds like silver steel (unhardened tool steel); I haven't tried machining with it. The closest element is Tantalum at 16.7 but it's not that because tantalum is soft.
The only marking on each piece is EDF 32851 and each piece is about 9 x 9 x 155mm.
Any ideas?
Phys.Org News Partner Engineering news on
Lawsuits challenge US drone, model aircraft rules
CU-Boulder leads international unmanned aircraft testing event at Pawnee Grassland
Gesture-controlled, autonomous vehicles may be valuable helpers in logistics and trans-shipment centers
Sep4-13, 04:19 PM
P: 2,179
Could it be tungsten carbide (density 15.6)? It is often used for drill bits.
Sep4-13, 04:46 PM
P: 4
That was quick- and I never thought of TC. It's not though because it can be filed, although it is quite hard. It appears to be cast then ground to clean up, but not precision ground; this might help as a clue.

Sep4-13, 06:39 PM
P: 160
Mysterious dense alloy

It basically has to be a tungsten alloy -- any other metal that dense is either too expensive and/or poisonous. So unless someone made a set of platinum drill bits, in which case you are pretty lucky, it's probably one of these, or something like them.
Sep5-13, 07:50 AM
P: 4
Fantastic! I spent hours searching without finding that. This seems very likely. In the link you provided, their rd17 material is made for boring bars where it's stiffness and high mass reduce chatter -vibration which leaves poor surface finish- when machining deep holes on a lathe. It would explain why this material turned up in a box of assorted engineering bits.
One day I'll get around to trying it out; when I do I'll report back.
Sep18-13, 03:35 AM
PF Gold
P: 330
Can't be depleted uranium can it? ;)
Sep18-13, 09:56 AM
P: 4
I'm not encased in a green glow so I'll stick with the tungsten alloy story.

Register to reply

Related Discussions
Show that f(E) is dense in f(X) if E is dense in X Calculus & Beyond Homework 1
Show that the preimage of dense set is dense? Topology and Analysis 2
Alloy compounds vs alloy solid solutions? Chemistry 1
Aluminum alloy Grains, Which alloy is it? Materials & Chemical Engineering 1
What is wrong with this picture? Fun, Photos & Games 11