What are Fission Recoil Fragments and How Are They Formed?

  • Thread starter RADboy
  • Start date
In summary, the conversation discusses various aspects of nuclear fission, including the formation and properties of fission recoil fragments and particles. It also mentions the use of aluminum plates to reflect and measure radioactive particles, as well as the differences between fission fragments of uranium and plutonium. The conversation also touches on the concept of absorption curve and the shift in mass population during fission.
  • #1
RADboy
13
0
i know the key word is "recoil" but, I'm reading a nuclear fission book and it keeps bringing up "fission recoil fragments" "recoil particles" what exactly are these particls? how are they formed? are they different from other ionizing particles other than the fact that they recoil?

A scientist was using thin sheets of aluminum (.57mg/cm thcik) to reflect the particles of neutron bombarded uranium. by measuring the radioactivity in each sheet he obtained a rough absorption curve 2.2+/- .2
 
Engineering news on Phys.org
  • #2
Well alpha particles are reflected by foils, so I suspect fission fragments are recoiling from the Al plate. Some will travel into the plate.

Look at Ernest Rutherford's experiments on the scattering of alpha particles at high angles.
 
  • #3
what's absorption curve? depending on the radioactive element can the particles ionize masses differently? does U-235 ionize mass differently than plutonium?
 
  • #4
RADboy said:
what's absorption curve? depending on the radioactive element can the particles ionize masses differently? does U-235 ionize mass differently than plutonium?
They could be looking for Linear Energy Transfer rate or distance that a fission product travels in a medium.

The fission fragments of U-236* and Pu-240* (* = composite nucleus after neutron absorption) are about the same. The lower mass population shift upward by Z=1, A=2 somewhat. The complementary pairs are different.

In UO2 or MOX, the fission tracks are about 3-6 microns, while in Al, they should be greater because the Al atom is lighter.
 
  • #5
RADboy said:
i know the key word is "recoil" but, I'm reading a nuclear fission book and it keeps bringing up "fission recoil fragments" "recoil particles" what exactly are these particls? how are they formed? are they different from other ionizing particles other than the fact that they recoil?

I think the recoil fragments are the pieces of the nucleus left over that recoil away from the emitted neutrons and alpha particles?
 
  • #6
"The fission fragments of U-236* and Pu-240* (* = composite nucleus after neutron absorption) are about the same. The lower mass population shift upward by Z=1, A=2 somewhat. The complementary pairs are different."


what exactly do you mean by the lower mass populatin shift upward by Z=1, A=2?
 
  • #7
RADboy said:
"The fission fragments of U-236* and Pu-240* (* = composite nucleus after neutron absorption) are about the same. The lower mass population shift upward by Z=1, A=2 somewhat. The complementary pairs are different."


what exactly do you mean by the lower mass populatin shift upward by Z=1, A=2?

When plotting yield vs atomic mass, one see a two hump/peak (bimodal) distribution, because the fissile nucleus splits into two nuclei.

http://hyperphysics.phy-astr.gsu.edu/hbase/nucene/u235cs.html#c1

http://hyperphysics.phy-astr.gsu.edu/hbase/nucene/u235chn.html

http://hyperphysics.phy-astr.gsu.edu/hbase/nucene/fisfrag.html
 

What are recoil fragments?

Recoil fragments are small pieces of debris or particles that are formed when a bullet is fired from a firearm. They are created due to the explosive forces within the gun and the impact of the bullet with the surrounding environment.

How are recoil fragments formed?

Recoil fragments are formed due to the explosion of gunpowder within the firearm, which propels the bullet forward. As the bullet travels through the gun barrel, it may also impact and scrape against the metal, causing small fragments to break off and become airborne.

Are recoil fragments dangerous?

Yes, recoil fragments can be dangerous if they come into contact with a person or animal. They can cause injury and even death if they enter the body. It is important to use proper safety precautions when handling firearms to minimize the risk of recoil fragments.

Can recoil fragments be detected?

Recoil fragments can be detected using various methods such as metal detectors or X-ray technology. They can also be visually identified on surfaces or objects that have been impacted by a bullet.

How can recoil fragments be prevented?

To prevent recoil fragments, it is important to use proper gun safety measures, such as wearing protective gear and using a suitable firearm for the intended purpose. Proper maintenance and cleaning of firearms can also help reduce the formation of recoil fragments.

Similar threads

  • Nuclear Engineering
Replies
9
Views
2K
Replies
14
Views
2K
  • Introductory Physics Homework Help
Replies
1
Views
749
  • High Energy, Nuclear, Particle Physics
Replies
6
Views
1K
  • High Energy, Nuclear, Particle Physics
Replies
4
Views
2K
  • High Energy, Nuclear, Particle Physics
Replies
1
Views
2K
  • High Energy, Nuclear, Particle Physics
Replies
6
Views
2K
Replies
25
Views
7K
  • Introductory Physics Homework Help
Replies
2
Views
2K
Replies
3
Views
1K
Back
Top