Register to reply

Useing single supply amp with split supply preamp?

by Tesladude
Tags: preamp, single, split, supply, useing
Share this thread:
Jun22-14, 03:35 PM
P: 135
I just finished a preamp/active crossover using the lm833n

but the amp I need to run it with is a class D single supply board.
and so the ground on the board is just negative.
Can I run my [high pass/ground/low pass] signal into this amp?
they are sharing a 24v power supply though and if I connect the pre amp boards ground to the class d boards ground then I am just crossing ground and negative because the class d boards ground IS negative.
Phys.Org News Partner Engineering news on
'Smart material' chin strap harvests energy from chewing
Lockheed Martin advances live, virtual, constructive training in flight test
Lockheed Martin conducts flight tests of aircraft laser turret for DARPA
jim hardy
Jun22-14, 08:16 PM
Sci Advisor
PF Gold
jim hardy's Avatar
P: 3,745
No takers yet ?

Basically you create a "fake signal ground" for the opamp at half the supply voltage.
Then you use capacitors at input and output to block the DC.

read the first few pages of this introductory application note from TI, it should get you started..

or you can get a small DC to DC converter that makes dual voltage
there's plenty of them around

but if you're an audiophile you may not want a switcher around your hi-fi gear.
Hmmm but then - isn't class D itself switching?
Please excuse the question - I'm an old 6V6 audio guy.
Jun23-14, 04:04 AM
P: 1,084
You have three different voltage requirements, VDD, VEE and GND for the LM833. How do you solve that? (obviously you don't)

You probably have an input capacitor into a divider in front of the LM833 to create a virtual ground. The output voltage is then 12V when there is no audio.

Put a capacitor in series with the 833 output and connect it to the Class D amp. Connect the class D between 0 and 24V and move on. (It probably has it's own input capacitor, but I'd use an external one unless you know the input circuit.)

Register to reply

Related Discussions
Earthed line in Split power supply in op-amp Electrical Engineering 2
Converting split supply amplifier to single supply Electrical Engineering 6
Computer power supply help.Want to know haw strong supply i need for my pc hardware. Computers 6
Dual supply vs single supply Electrical Engineering 4
Single supply op-amp configuration Electrical Engineering 6