
#1
Mar1512, 09:49 PM

P: 1

I am trying to measure the heat transfer from a sealant curing oven. My methods were to measure the surface temperatures of the inside and outside of the oven with 4 Ttype thermocouples as well as the wattage supplied to the oven via a wattnode. The curing process is typically a 2 hour interval from cold start to finished. I have plotted the graph of watts vs time and calculated the areas under the curve to find the total energy during a two hour heating process (started from cold). The response of the wattage vs time is square as the controls on the oven are binary. I also have plotted the temperature vs time graphs. For some reason I cannot seem to wrap my head around my next step. By the principle of conservation of energy the watts in should equal the watts out of the oven (neglecting losses from the cables, etc). My problem is this. A watt is a J/s so if I multiply the watts by time (to find area under curve) I end up with a Joule and not the required watts for the units of heat flux. My goal is to find an effective Rvalue for the oven and eventually determine the mass flow rate out of the oven in order to determine how much steam I will need to increase the relative humidity too 50%. If anyone can point me in the right direction it would be truly appreciated. I have attached the graphs.
The response curves are for the inside/outside walls of the oven and door. The door is a single acrylic panel and the walls insulated and covered with steel panels on either side. Cheers, Paul 


Register to reply 
Related Discussions  
equation measuring heat with temperature change, time and specific heat  Classical Physics  7  
How to transfer heat dissipate by heat sink into one spot  Mechanical Engineering  3  
Calculate the mass of ice with heat transfer / latent heat  Introductory Physics Homework  3  
Is the overall heat transfer coefficient constant for a certain heat exchanger?  Advanced Physics Homework  0 