- #1
atlbraves49
- 81
- 0
I could use some tips on the following setup..
Will have a larger wire (i think its 14 AWG) going into a metal box, but then inside the box i need to switch over to smaller wires (breadboard type) for the circuitry inside. Is that possible? And if so, how do i go about making that switch over.
Just a basic idea of what I am talking about.. the red wire is the larger wire, and the blue wire is what's connect to a breadboard inside the box
http://img3.imageshack.us/img3/737/wiringgr8.jpg
Will have a larger wire (i think its 14 AWG) going into a metal box, but then inside the box i need to switch over to smaller wires (breadboard type) for the circuitry inside. Is that possible? And if so, how do i go about making that switch over.
Just a basic idea of what I am talking about.. the red wire is the larger wire, and the blue wire is what's connect to a breadboard inside the box
http://img3.imageshack.us/img3/737/wiringgr8.jpg
Last edited by a moderator: