Register to reply

Basic Hydraulics: Flow, Pressure, Force, Area, Energy

Share this thread:
thender
#1
Nov18-13, 09:47 PM
P: 29
Hello, I am trying to get a grip on the basic relationships in hydraulics. I do not need the advanced math and engineering, compensation for frictional losses, and fluid viscosity and turbulence effects. Just a good basic understanding.

The first concept that comes to mind is the concept of energy, I believe the total energy in a system is the sum of the potential and kinetic energies. And that energy within a system is the conserved property. Like the amount of work that can be done, has been done, and is being done if added up should always be the same in a closed system.

Another concept is Pressure. I believe that pressure describes force distributed by a fluid over an area. Force is something that can be measured for a fixed area. Like if I have 100 PSI and apply it to something with .5 square inches, it generates 50 pounds of Force.

I consider flow to be the mass of a fluid per unit time that moves past a point. I think that's the volumetric flow rate.

A related concept is the velocity of the flow.

Flow seems to be related to the pressure differential between two points.

And by this point I've lost my grip.

Using a basic example, if I open the faucet outside and let water flow out of a garden hose, it will come out steadily, if I then restrict the hose by placing my thumb over the end, the water gushes out violently.

I don't believe that restricting the hose with my thumb changes the total energy in the system.

I think that the water sprays out farther because its force increased, and its force increased because the same pressure was applied to a smaller area.

Flow probably decreased. If I compare a faucet that is only slightly cracked open, it will just drip, compared to one fully open that is gushing, I think the flow is inversely related to the restriction.

I'm lost.

In the same system I can have high pressure, low flow output, or high flow, low pressure output. So I think flow * pressure = power (conserved).

And I think flow is proportional to the difference in pressures and the area. A higher pressure differential should result in more flow for an orifice of the same area. And a larger orifice should increase flow. So flow = pressure1 / pressure2 * area.

Thus putting my finger over the end of a garden hose reduces the effective area the pressure differential is applied across, which reduces the flow, and increases the pressure, result - spraying water ten feet.

HELP! I need basic working theory!
Phys.Org News Partner Engineering news on Phys.org
Research project on accident-avoiding vehicle concluded
Smaller artificial magnetic conductors allow for more compact antenna hardware
Autonomy expert led team in developing "self-flying planes"
pantaz
#2
Nov19-13, 04:00 PM
P: 589
This might help: http://hydraulicspneumatics.com/eboo...d-power-basics
The writing is tailored more towards industrial users, but it should answer many of your questions.
Travis_King
#3
Nov19-13, 05:26 PM
P: 850
Mass of the fluid per unit time is mass flow rate. Volume of the fluid per unit time is the volumetric flowrate.

I wrote a post in another thread a while back which might help a little, too. http://www.physicsforums.com/showthread.php?t=674896


Register to reply

Related Discussions
Hydraulics, Flow rate from Bernoulli Equation Engineering, Comp Sci, & Technology Homework 2
Pressure= Force/ Area Introductory Physics Homework 6
Pressure, force, and Area: Calculating the net Force Applied on A dam by Water Introductory Physics Homework 1
Pressure = Force/Area Introductory Physics Homework 9
Determine Force/pressure from air flow? Mechanical Engineering 10