- #1
dislect
- 166
- 0
hi everyone!
i was wondering how gear reduction is done besides connecting a small gear to a larger gear (radius speaking)?
In my problem i have a gear - radius:5cm, angular velocity: 1000rpm
I have a second gear - radius:5 cm, anguler velocity required: 1 rpm
How do i make this happen? do i play with the numer of "teeths" on each gear, say that the first has 1 teeth and the second has 1000?
Thanks
i was wondering how gear reduction is done besides connecting a small gear to a larger gear (radius speaking)?
In my problem i have a gear - radius:5cm, angular velocity: 1000rpm
I have a second gear - radius:5 cm, anguler velocity required: 1 rpm
How do i make this happen? do i play with the numer of "teeths" on each gear, say that the first has 1 teeth and the second has 1000?
Thanks