Register to reply 
When do we need npoint functions for high n? 
Share this thread: 
#1
Jul214, 01:40 PM

P: 119

I am new to QFT and found myself wondering the following. Particle physics experiments usually consist of looking at what happens when we smash two protons together. As such, we look to calculate amplitudes for 2> n scattering, with n the number of particles that emerge from the other side. Is there ever a case in which we need to think about this for high n? And if not, why need we worry about the divergences npoint Green's functions being cured for lower n, since we're unlikely to have to use them to calculate anyway?
Any thoughts most appreciated! 


#2
Jul214, 02:42 PM

Sci Advisor
P: 1,587

Highenergy QCD collisions produces loads of particles, not just a few:
http://en.wikipedia.org/wiki/Jet_%28particle_physics%29 


#3
Jul214, 05:26 PM

Mentor
P: 11,576

Usually the calculation is split up in the hard interaction (producing heavy bosons, heavy quarks, highenergetic quarks, gluons, photons or whatever happens in the event) and hadronization (can produce jets). 


#4
Jul314, 04:07 AM

P: 355

When do we need npoint functions for high n?
That only works for actual hard scattering events right? I am not sure that events with lots of soft quarks and gluons factorise so nicely.



#5
Jul314, 05:26 PM

Mentor
P: 11,576

I don't know about ALICE (and if lead is involved, you need a different approach anyway), but ATLAS and CMS mainly look for hard scattering events  everything else does not even pass the first stages of the triggers (well, just with a tiny rate to have some unbiased sample). LHCb looks at lower energies, but even there everything below 23 GeV (for the final decay products) is background because it does not make it through the magnet.



#6
Jul314, 07:22 PM

P: 355

Sure. I guess the main answer to the OP is that it is theoretically important to know these things, even if they are not part of the "everyday toolkit" of experimental particle physics. Though I have no doubt that some QCD expert would indeed think these things super important for the experiments, for modelling the SM backgrounds properly and so on.



#7
Jul614, 03:19 PM

P: 82

The Parton shower does an approximate high n.
The hard suborocess which you calculate the matrix element for using your Feynman rules receives higher order corrections from infrared divergences (real and virtual). So in some sense, the shower does the large n part for you. This is done through leading logarithmic approximation. This is only accurate for corrections (large n) which are in a particular regime  collinear, soft. Calculation wise, this is what is reasonably feasible. So large n is important for calculating the shape of a particle distribution in part of phase space sensitive to these un calculated extra corrections. (Eg pt near 0, where real corrections are turbo fuelled) 


#8
Jul2014, 04:57 AM

Sci Advisor
P: 303

If some of the npoint functions diverge, then it means that the innerproducts between certain states are undefined, that is the transition amplitude from some state to some other state is illdefined and since the collection of all transition amplitudes essentially tells you the time development of the state, it would mean that the time evolution was illdefined. If only the npoint functions for low n were defined, it would mean that the theory only had sensible time evolution for initial configurations with low particle numbers, for all other states it developed divergences. Such a theory couldn't be said to accurately reflect the real world. 


Register to reply 
Related Discussions  
What is the point of studying maths at a very high level?  General Discussion  36  
Finding the freezing point of water at high pressures  Advanced Physics Homework  1  
Wave function at high symmetry point  Atomic, Solid State, Comp. Physics  7  
High symmetry point in GaAs superlattice  Advanced Physics Homework  0  
Melting point at high pressure.  Chemistry  0 