Maxwell 3D

Patxi

Hello all,

I want to simulate a permanent magnet generator, but when once I have done the plot and I want to simulate it, I meet problems with the memory, I think the design of the generator is to big. I have seen in some pappers that there is the option of ploting a part of the generator, for instance a quarter or 2 poles. Do you know if this is posible? Is there any tool or option where I can do this? Could I run the simulation only with this part and have the solution for all the machine?
How can I do the simplification of the design?

In this site, on the right part you can see what I mean:
http://www.ansoft.com/products/em/maxwell/new.cfm

Thanks