Hydraulic Press Question


by vtc
Tags: hydraulic, press
vtc
vtc is offline
#1
May14-10, 07:27 AM
P: 1
Where I work we machine hubs for agricultural equipment. Currently we are having an issue pressing the cups\races into the hubs. The cups have a.001 inference fit with the bore of the hub. The hub dia is 3.2675" and the cup has a 3.2685" dia. the surface finish of the hub is 125 and I am not sure what the surface finish is for the cup. Also we are pressing the cup to a depth of 1.5". The question that has been asked of me is to calculate the amount of psi it takes to press the cups into the hub. Any help would be appreciated. Thanks
Phys.Org News Partner Science news on Phys.org
Cougars' diverse diet helped them survive the Pleistocene mass extinction
Cyber risks can cause disruption on scale of 2008 crisis, study says
Mantis shrimp stronger than airplanes
FlexGunship
FlexGunship is offline
#2
May14-10, 09:42 AM
PF Gold
FlexGunship's Avatar
P: 735
Not sure if it helps... but I've used this before:

http://www.tribology-abc.com/calculators/e3_8.htm


Register to reply

Related Discussions
Hydraulic Press Formula General Physics 9
Hydraulic press and compressible fluids General Physics 0
Hydraulic press and compressible fluids Mechanical Engineering 0
Hydraulic press Introductory Physics Homework 1
hydraulic press Introductory Physics Homework 4