| New Reply |
has anyone worked with cam and follower mechanisms? |
Share Thread | Thread Tools |
| May25-11, 07:04 PM | #1 |
|
|
has anyone worked with cam and follower mechanisms?
i need to design a radial cam with oscillatiing follower .
the follower should rise with an angular deflction of 120 degrees how should i go about this in solidworks 2010 cam toolbox... my second question is..will the drawing i make in solidworks be enough to give to the manufacturer to fabricate this cam?... |
| New Reply |
| Thread Tools | |
Similar Threads for: has anyone worked with cam and follower mechanisms?
|
||||
| Thread | Forum | Replies | ||
| Emitter follower design. | Engineering, Comp Sci, & Technology Homework | 17 | ||
| Voltage follower not working | Electrical Engineering | 4 | ||
| Emitter Follower | Advanced Physics Homework | 0 | ||
| Reason for Resistor Before an Op-Amp Follower? | Electrical Engineering | 4 | ||
| Classify Cam-Follower pair in Cam-follower mechanism as....?? | Mechanical Engineering | 0 | ||
Physorg.com Science News Partner
