Register to reply

Testing my B-spline surface function

by roldy
Tags: bspline, function, surface, testing
Share this thread:
roldy
#1
Feb19-12, 08:32 PM
P: 194
I have created a program in MATLAB that creates a b-spline surface from a set of (x,y,z) points. I would like to see if my program works before I develop it into a full program (user interface plus lots of options). Here's what I'm asking...

Could someone generate a b-spline surface of degree 2 in both the u and v direction. Let's make the number of (x,y,z) control points 4 in both the u and v direction. I'm not sure what software will make a b-spline surface for you with the option to change the degree. This would be very helpful. I would like to finish this so that I can post this program here.
Phys.Org News Partner Science news on Phys.org
Suddenly, the sun is eerily quiet: Where did the sunspots go?
'Moral victories' might spare you from losing again
Mammoth and mastodon behavior was less roam, more stay at home

Register to reply

Related Discussions
MATLAB program for B-spline surface Math & Science Software 10
Testing to see if an Equation is a function General Math 4
Re: Building a hydrodynamics water tunnel for surface water wheel testing. General Engineering 4
Hypothesis Testing: Power Function Calculus & Beyond Homework 12
Issues testing a tachometer with a function generator Electrical Engineering 4