Register to reply 
Question 1by kyang002
Tags: None 
Share this thread: 
#1
Feb405, 03:57 AM

P: 22

What is the electric flux through the surface shown in the figure (attachment)?



#2
Feb405, 04:02 AM

Sci Advisor
HW Helper
PF Gold
P: 12,016

What ideas do you have?



#3
Feb405, 04:03 AM

P: 22

I'm unsure of how to do this problem. No ideas so far.



#4
Feb405, 04:07 AM

Sci Advisor
HW Helper
PF Gold
P: 12,016

Question 1
What is the definition of electric flux?
(Look up in your book) And, do NOT double post (posting the same question twice or more), and show your own work or at least your ideas/what you are uncertain of in the future. 


#5
Feb405, 04:52 AM

P: 2,056

Well, of course as he/she said: he/she has no ideas so far



#6
Feb405, 05:07 AM

Emeritus
PF Gold
P: 734

Just saying "I have no idea" is like asking to NOT be helped. At least, for sure, kyang002 can find the definition of electric flux, and then try at least to correlate it with the problem.
Actually, just typing the definition here will provide a starting point for others to help. 


#7
Feb405, 10:39 AM

P: 641

I think writing down the equation for electric flux would just about answer this question completely....(after plugging in 2 numbers)



#8
Feb405, 02:04 PM

P: 22

Electric Flux would be E x A or EA cos theta.



#9
Feb405, 02:06 PM

P: 22

The answer is 1. But I have no idea of doing it. Again no help is given.



#10
Feb405, 02:15 PM

Sci Advisor
HW Helper
P: 11,896

[tex] \vec{E}\times\vec{A}=EA\cos\theta [/tex] That "x" would invite to an erroneous interpretation. To the OP:It's only about applying the (simple) definition and using a bit of trigonometry... Daniel. 


#11
Feb405, 02:45 PM

P: 641

Ok, they give you E,A,and theta. PLUG IT IN A CALCULATOR You see, flux is the measurement of the field passing through the surface, times the area of the surface (simplest, non integral way). So if your field is at a 30 degree angle to the horizontal surface, you need whats passing perpindicularly(rightangle) to the surface. So its a right triangle, / /   And if you want the Y edge, Cos(left angle) = Height/Hypot Hypot = E field so Efield*(cos(theta)) = Height So E*Cos(theta) * Area = fllux 


#12
Feb405, 02:48 PM

Sci Advisor
HW Helper
PF Gold
P: 12,016

kyang:
1. Could you identify the quantities you have been given? 2. Where should those quantities be plugged into the formula you have presented? (That is, the flux is given by [tex]EA\cos\theta[/tex]) Note: Be careful with the angle! 


#13
Feb405, 02:57 PM

P: 22

Now I understand. Thanks guys.



Register to reply 