Register to reply

BJT help

by go2255
Tags: None
Share this thread:
go2255
#1
Mar1-14, 12:41 AM
P: 11



This is the result from a lab,but I am not sure the results are correct.
Also,when I try to find I(c) , I(b) and I(e),by measured V(RC) and V(RE),I find the results strange.
I guess the combination of R1=10k and R2=10k is under linear region,but the dc gain is so small.
For combination of R1=10k and R2=1k,Idon't know why the I(b) is negative.Is it the cut off mode?
And for combination of R1=1k and R2=10k,it should be in saturation?
I guess R2 is like a battery so current I(b) flow ,but how about R1??
Attached Thumbnails
20140301_140811 (1).jpg  
Phys.Org News Partner Science news on Phys.org
'Office life' of bacteria may be their weak spot
Lunar explorers will walk at higher speeds than thought
Philips introduces BlueTouch, PulseRelief control for pain relief
NascentOxygen
#2
Mar1-14, 06:39 AM
HW Helper
Thanks
P: 5,496
You calculated IB using IE - IC. This can be inaccurate when IE is close in value to IC.
There is another way you can determine the value of IB in each test situation, it's a more accurate method, too.

What is this second method I speak of?


Register to reply