Cars and pedastrians are controlled by switch and we dont use latches. We create state machine and use vhdl to implement program in CPLD circuit.
Hope that answer your questions.
Hi,
I got this instruction given:
> For each of the following three scenarios, initially assume that the East-West traffic has had a green traffic light for a long time.
1) If a North-South car is detected then the traffic lights will cycle to green in that direction. The walk light will...
Homework Statement
Hi I got this problem and have to fill out this table.
Homework Equations
node analysis
time constant = RC
ic(t)= C dVc(t)/dt
The Attempt at a Solution
I got few answers which i worked it out.
i (0-) = 0
Vc(0-) = 1.84
Vr(0-) = i (0-) *...
Homework Statement
A stove burner supplies heat to a pan at the rate of 1500 W. How
long will it take to boil away 1.1 kg of water, once the water
reaches its boiling point?
Homework Equations
q = mct
The Attempt at a Solution
heat transfer = 1500 W, m = 1.1 KG Tf = 100
[
Homework Statement
A crane in a marble quarry is mounted on the rock walls of the quarry and is supporting a 2000 kg slab of marble as shown in the figure. The center of mass of the 900 kg boom is located one-third of the way from the pivot end of its 15-m length, as shown.
Given...
Homework Statement
Homework Equations
How to do this question ??
The Attempt at a Solution
I know sum of torque and force = 0
at fapplied i got torque = 25sin(45) * 3.8m = 67.18N ..
But dont know what to do next !!!
Other Force problem !!!
Homework Statement
Two forces act on a 3.1 kg mass, which undergoes acceleration a = 0.88 i - 0.28 j m/s2. If one of the forces is F1 = - 1.5 i - 3.0 j N, what is the other force?
Homework Equations
I don't know how to visualize this !!!!
The Attempt at a...
Hi, below image. My teacher use symbol in K-MAP. But not sure how it uses.
Myattempt : i got
0 0 0 0
0 0 1 1
0 0 1 1
0 1 1 0 --> Using his technique.
Can somebody help me out ?
Homework Statement
A mass m slides along a frictionless horizontal surface at speed v initial. It strikes a spring of constant k attached to a rigid wall. After a completely elastic encounter with the spring, the mass heads back in the direction it came from.
(a)In terms of k, m, and v...
How to Take the sum of moments !!!
Homework Statement
Hi i am doing static equilibrium exercises in textbook.
Homework Equations
But I dont know how to find sum of moments at P when its come to angle.
This is a drawing
The Attempt at a Solution
I have No idea !!! I was...
Homework Statement
physical reasons for the relationship between weight change(100CC beaker with water and when you dip aluminum block in water ) and apparent loss in weight of the aluminium (Aluminium block weight using spring balance and when that block immersed in water)
Homework...
Homework Statement
does surface area to affect the values of coefficient µk?
Homework Equations
frictional force =µk * normal force
The Attempt at a Solution
I know that if mass is larger then the frictional force is higher( f= ma)
but how about the surface area? does it affect...
Homework Statement
[Broken]
Homework Equations
impedence diagram, XL = ωL
The Attempt at a Solution
Ok i got XL = 47 ohm
Then my phase angle is 88.8 degree.
Then to find i(t) i have to add that angle to the function right?
Awaks.. IT is solution of the Electrical Engineer : priniciples and application Hambley book.
And they made it wrong. I asked the question though i was wrong.
Homework Statement
I am following book and they got this equation but i dont know how they got it ??
[Broken]
Homework Equations
The Attempt at a Solution
I know they use kirchoff's voltage law but at which point they are choosing and how they are going and acquire this...
Homework Statement
A circuit consists of a 50nF capacitor in series with a 47kΩ resistor. An AC voltage of 120Vrms at
350Hz is applied to the circuit.
(a) Determine the current flowing through the circuit.
(b) Sketch the impedance diagram for the circuit at this frequency.
Homework...