Search results

  1. I

    Solving complex equation

    Mathematica would solve that sort of equation just fine. So would Maple and Matlab for that matter. www.wolframalpha.com would also suffice. As for solving it by hand, I dont see any clear way to do it without a whole lot of work.
  2. I

    Potential difference given velocity of electron at 2 points

    No. You are not missing anything. When carrying out sig figs, it really should be two but many systems use three automatically.
  3. I

    Rotational Motion of a penny

    yes. So youll notice that the mass does not actually matter in the question since it cancels out.
  4. I

    Potential difference given velocity of electron at 2 points

    Perhaps you need a more precise answer like 1.75. If the homework system you are using is something like UTexas, 3 decimals are needed as they only tolerate 2% error.
  5. I

    Rotational Motion of a penny

    Ok. Let us begin with this question. You are given the frequency of the LP (and thus the period as well), and you are given the mass of the penny. As you have written above, Frictional Force = co-eff * Normal and centripetal acceleration = v^2/r = 4Pi^2r*frequency^2. For the penny to stay on the...
  6. I

    Destructive interference in a speaker value

    Ahh. I see my mistake. My mistake was assuming that the Path Difference/ Wavelength = 0.5. A value of 0.5 for the P.D./wavelength is not the smallest path difference. From a bit of trial and error, you will see that 2.5 (i.e. n=2, n+0.5 = 2,5) creates the smallest path difference with an answer...
  7. I

    Destructive interference in a speaker value

    The work you did seems to be on the right track, but perhaps use of different notation will clear things up. Since one speaker is located at the origin (0, 0) and the other speaker is located at (0, 4), we do not need the co-ordinates of the Point P1-P2 but rather its distance: Since the Path...
  8. I

    Tuning fork frequency!

    You will need to know about standing waves and possible wavelengths to produce standing waves. Have you been taught the derivation of the formula Wavelength = 4L/(2n-1) where n is the nth harmonic? (Usually this is Taught as 4L/n where n = 1, 3, 5.. etc.
  9. I

    Charged particle in a cloud chamber?

    As pgardn mentions above, a magnetic field interacts with a charged particle in quite a peculiar way. Similar to a ball being spun on a string, the magnetic field exerts a centripetal force to the component of the charge's velocity that is perpendicular to the field (whew. that sounded like a...
  10. I

    Speed of Transverse Wave

    Ah but think about it. Say we're looking at one interval of a cosine curve (0 to 2pi). How many max points are there? How many points cross y = 0? The points that cross y = 0 are like the nodes (when you multiply the cosine curve by -1 they remain invariant) while the antinodes are the points...
  11. I

    Speed of Transverse Wave

    For a wooden bar with anti-nodes on both sides, the formula for wavelength is: Wavelength = 2L/n, where L is the length of the bar and n is the harmonics number. For three antinodes and 2 nodes, the bar is in its second harmonic and so wavelength is: 2L/2 = L Since Frequency*Wavelength =...
  12. I

    Calculating Work done by the Earth and the work done by the Spring

    Part B mainly requires for you to calculate the difference in the kinetic energy.
  13. I

    Two Solenoids on top of each other?

    Precisely. Good luck on the rest of the question.
  14. I

    Maximum velocity of circular motion

    Hello clombard1973, let me start off by saying something that many people should have said to you upon registering at this forum: Welcome to physicsforums.com. As for your reply to my post, I admit it was a rather snide remark on my end. However, doubt is part of the scientific method and it...
  15. I

    Two Solenoids on top of each other?

    I believe you would use four turns, as the flux is induced in the four turn coil by the 121 turn coil. You will need to know that: Change in Flux = Change in Field * Cross sectional Area Change in field = permeability of a vacuum x N x A x (I/t) / length **Note that it is N and not N^2 as you...
  16. I

    Maximum velocity of circular motion

    I find the above post very difficult to swallow. I believe that the force of gravity on the mass must be included in the 25 N of breaking tension (of course I do not have "four advanced degrees in electrical engineering and a doctorate" as clombard1973 claims). Thus, the breaking tension is...
  17. I

    Water flowing from an open tank

    When you have a large tank and a small leak, it can take forever for the tank to drain (this is because it has a large cross-sectional area on top so the height of the liquid only decreases a little when a lot of volume goes out). Alternatively, when you have a small tank and a large leak, the...
  18. I

    Mass on a spring(SHM)

    Your work looks right. The mass for the period should be 55g.
  19. I

    Mass on a spring(SHM)

    The mass of the spring do not need to be used as stretching with 55g stretches from the equilibrium state (the equilibrium state holes the 45g from the spring and system)
  20. I

    Block + Ramp

    Hm.. Thanks guys
  21. I

    Block + Ramp

    So what do I use for the initial velocity of the block on the ramp? It cant be v', can it? Also, the v' refers to the velocity of the system, but how do you determine the velocity of the ramp itself to the ground?
  22. I

    Block + Ramp

    Edit: The mass of the ramp is known.
  23. I

    Block + Ramp

    Homework Statement A block of m mass slides along a frictionless horizontal surface with a speed of v m/s. After sliding a distance of d, the block makes a smooth transition to a frictionless ramp inclined at an angle of theta ° to the horizontal. The ramp is not fixed to the frictionless...
  24. I

    Parachute motion question

    Thats quite a big error you have in calculating for potential energy there. The concept is right. The calculations are wrong.
  25. I

    Parachute motion question

    Force. The potential energy incolves the 1000 m of height.
  26. I

    How many moles of gas are in the balloon?

    = [. I said that earlier. I'm sad now.
  27. I

    How many moles of gas are in the balloon?

    Also, you squared your radii instead of cubing it.
  28. I

    Parachute motion question

    Since force is constant and motion is one dimensional, our best friend in this case is the F*d = W, mgh = PE, and 0.5mv^2 = KE equations. There is "positive" energy from the used potential energy in the fall and there is "negative" energy (force is acting opposite to direction of motion) from...
  29. I

    Collision of billiard balls

    They are identical billiard balls I assume, in mass and otherwise.
  30. I

    Mass of the sun equation

    Check your orbital period. Make sure you convert the year into seconds and then square it.
Top