Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Trending
Featured Threads
Log in
Register
What's new
Search
Search
Search titles only
By:
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Menu
Log in
Register
Navigation
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Engineering
Materials and Chemical Engineering
1018 carbon steel tensile test explanation
Reply to thread
Message
[QUOTE="jrmichler, post: 6260411, member: 638574"] For starters, your numbers are completely wrong for any type of steel. AISI 1018 steel could have a yield somewhere near 50 KSI if is was cold rolled, but a yield stress of 50 MPa (7.25 KSI) is not steel. A strong plastic, maybe, but not steel. Similarly, a yield strain of 0.04 is way beyond any steel on this planet. Go back and take a long hard look at the experimental setup. How is the force and strain measured? Has the equipment been calibrated? Recheck every step of your calculations. And add units to the labels in your spreadsheet. [/QUOTE]
Insert quotes…
Post reply
Forums
Engineering
Materials and Chemical Engineering
1018 carbon steel tensile test explanation
Back
Top