1. Limited time only! Sign up for a free 30min personal tutor trial with Chegg Tutors
    Dismiss Notice
Dismiss Notice
Join Physics Forums Today!
The friendliest, high quality science and math community on the planet! Everyone who loves science is here!

ALUs in CircuitMaker

  1. Feb 2, 2012 #1
    1. The problem statement, all variables and given/known data

    You must construct the following layout :

    circuit.png

    and simulate it, additionally using switches and lights for data input and display.

    The simulation must carry out the operation X + Y -> X.

    Produce a table of control switch settings which carries out the operation described.



    I'm guessing that X, Y, A should be gates, and O should be the output? Do you think that's correct? Also for the ALU, how does that work? I've never used ALUs in CircuitMaker before so I'm not quite sure how they work.


    2. Relevant equations

    N/A


    3. The attempt at a solution

    N/A, just asking a few questions
     
  2. jcsd
  3. Feb 2, 2012 #2
    X, Y, A, O are registers few bits

    http://cdn3.asteroid.pl/c15/a.fotka.pl/080/059/80059414_800_s.jpg [Broken]
     
    Last edited by a moderator: May 5, 2017
Know someone interested in this topic? Share this thread via Reddit, Google+, Twitter, or Facebook