Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Trending
Featured Threads
Log in
Register
What's new
Search
Search
Search titles only
By:
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Menu
Log in
Register
Navigation
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Engineering
Electrical Engineering
ANSYS - Maxwell, current distribution plot?
Reply to thread
Message
[QUOTE="PhiowPhi, post: 5901438, member: 524521"] I was modeling current distribution in a component: [ATTACH=full]216667[/ATTACH] And I plotted the ##\vec J## to simulate & understand the current distribution throughout the conductor, all the flows make sense, however, at the edge of the conductor like so: [ATTACH=full]216668[/ATTACH] Current would distribute all around the area, which is expect. However, one would initially assume that the highest ##\vec J## would be going towards the potential difference applied(which is the lower right bar extending to the right of the page) which I would assume is ##1.93 \times 10^7##, and over the furthest left edges possibly low distribution at ##1.71 \times 10^2##, but I'm not sure. Is there a way I could figure this out through ANSYS? Even when I apply really higher currents(From 250##A## to 250##kA##) the diagram would change to this distribution: [ATTACH=full]216674[/ATTACH] Which leads to the same problem, dark blue being a range of [##1.73 \times 10^2##,##1.93 \times 10^7##] My initial assumption is the least amount of current in that scale list is towards the edges in dark-blue. [/QUOTE]
Insert quotes…
Post reply
Forums
Engineering
Electrical Engineering
ANSYS - Maxwell, current distribution plot?
Back
Top