Dismiss Notice
Join Physics Forums Today!
The friendliest, high quality science and math community on the planet! Everyone who loves science is here!

Aspect Ratio of Continuous Cast Rolled Steel

  1. Jun 21, 2016 #1
    We have a requirement that if our pipe is going to be fabricated from plate, then it must have a larger than 6-to-1 reduction from the original conventionally cast ingot or continuously cast slab. It is not specified whether this would be hot/cold rolling, but we figured that .5 inch plate would most likely exceed this, but we are not sure. Does anyone have any suggestions? Is there a standard where this information could be found, or perhaps an engineer from the milling industry?
     
  2. jcsd
  3. Jun 26, 2016 #2
    Thanks for the post! This is an automated courtesy bump. Sorry you aren't generating responses at the moment. Do you have any further information, come to any new conclusions or is it possible to reword the post?
     
Know someone interested in this topic? Share this thread via Reddit, Google+, Twitter, or Facebook

Have something to add?
Draft saved Draft deleted