Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Trending
Featured Threads
Log in
Register
What's new
Search
Search
Search titles only
By:
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Menu
Log in
Register
Navigation
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Engineering
Mechanical Engineering
Calculations for a lifting tool for a bar
Reply to thread
Message
[QUOTE="oblong-pea, post: 6850117, member: 670528"] Thanks for the reply It will be steel, and I'm planning to use a system that goes around the disc/ flared head and clamps underneath (lifting from the underside of the disc) and lifts up from there. I'm aiming to make it something that connects to a crane or similar system so it's hoisted up; where the stroke would be more than 10m, possibly 12m giving 2m clearance. The bar is in a guide tube, so shouldn't jerk when be removed until its clear of this guide tube, however its indoors so there won't be any wind considerations. [/QUOTE]
Insert quotes…
Post reply
Forums
Engineering
Mechanical Engineering
Calculations for a lifting tool for a bar
Back
Top