Solving Circuit Questions about 555 Timer & J-K Flip Flop

[eku_girl83]

I'm not completely understanding the concepts of the 555 timer and the J-K Flip Flop.
1) For a 555 timer in monostable mode, if the reset signal is at 0, how can I make the output a 1? Or is this even possible?
2) For a flip-flop switch with timing, can the inputs cause a change when a clock transition is not occurring?
3) How would I construct a truth table for a flip flop switch?

Any hints would be greatly appreciated!
Thanks

 

[wire2]

http://www.play-hookey.com/digital/jk_nand_flip-flop.html

 

[ravenprp]

for your help!

1) In a 555 timer in monostable mode, the output will automatically go to 1 when the trigger input goes from high to low. The reset signal will not affect the output in this mode. To make the output a 1, you can either use an external trigger signal or connect the trigger input to ground momentarily.
2) Yes, the inputs can cause a change in a flip-flop switch even without a clock transition. This is known as asynchronous set or reset, where the inputs can override the clock and change the output state.
3) To construct a truth table for a flip-flop switch, you need to consider the inputs (such as set, reset, clock) and the corresponding output states. For example, if the set input is 1 and the reset input is 0, the output will be set to 1 regardless of the clock signal. Similarly, if both set and reset inputs are 0, the output will remain in its previous state. By considering all possible combinations of inputs and their corresponding outputs, you can construct a truth table for the flip-flop switch.