Gambit meshing errors

  • Thread starter Vnt666Skr
  • Start date
I am quite new to using Gambit and I having problems with mesh generation for my helical tube. I split the entire volume into 4 smaller volumes. Now, when I try to mesh each one of them errors start to crop up. These are the errors associated with the meshing of each volume

1. independent loops of swept faces on volume 2 had mismatched intervals
2. natural source face for projecting volume 3 could not be found
3. the intervals would force the mesh to cross itself could not be meshed using cooper scheme
4. check the interval assignments for correctness volume 7

One of the volumes[shows 'meshing face 4' and it never ends] take very long to mesh and the process eventually terminates saying not enough memory.

Pls help me out.!

Here's the screenshot of my model in Gambit

Want to reply to this thread?

"Gambit meshing errors" You must log in or register to reply here.

Physics Forums Values

We Value Quality
• Topics based on mainstream science
• Proper English grammar and spelling
We Value Civility
• Positive and compassionate attitudes
• Patience while debating
We Value Productivity
• Disciplined to remain on-topic
• Recognition of own weaknesses
• Solo and co-op problem solving