1. Limited time only! Sign up for a free 30min personal tutor trial with Chegg Tutors
    Dismiss Notice
Dismiss Notice
Join Physics Forums Today!
The friendliest, high quality science and math community on the planet! Everyone who loves science is here!

Gear generator from existed parameters

  1. Jul 2, 2010 #1
    Hi all, is there any one used to design by using Inventor

    There's a bit trouble for me when build model of pinion from table of parameters as picture below, I hadly know exactly which parameter is equivalent with abriviation in "insert ifeature", certainly not all parameter, just a few as modulus, pitch diameter, refence diameter, base diameter.... but will be the best if showing all input into insert ifeature

    [PLAIN]http://img580.imageshack.us/img580/521/calci.jpg [Broken]
    [PLAIN]http://img62.imageshack.us/img62/5664/ifea.jpg [Broken]
    [PLAIN]http://img444.imageshack.us/img444/3141/feart.jpg [Broken]
    Please don't laugh at me, i really don't know, moreover, which grade or value of tolerances we should use with center distance 331.494 mm as in attached picture.

    Thanks for sharing if any
    Last edited by a moderator: May 4, 2017
  2. jcsd
Know someone interested in this topic? Share this thread via Reddit, Google+, Twitter, or Facebook

Can you offer guidance or do you also need help?
Draft saved Draft deleted