Insights Blog
-- Browse All Articles --
Physics Articles
Physics Tutorials
Physics Guides
Physics FAQ
Math Articles
Math Tutorials
Math Guides
Math FAQ
Education Articles
Education Guides
Bio/Chem Articles
Technology Guides
Computer Science Tutorials
Forums
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Trending
Featured Threads
Log in
Register
What's new
Search
Search
Search titles only
By:
General Engineering
Mechanical Engineering
Electrical Engineering
Aerospace Engineering
Nuclear Engineering
Materials Engineering
Menu
Log in
Register
Navigation
More options
Contact us
Close Menu
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Engineering
Mechanical Engineering
Gearbox design-Is this design possible to make the output shaft thin?
Reply to thread
Message
[QUOTE="Lnewqban, post: 6485042, member: 673625"] Another solution to a marginal output shaft diameter could be a coupling between it and an independent shaft, supported by two bearings, for the pulley, which could be mounted in a cantilever set for easy belt replacement. Careful alignment should be performed for both shafts, in order to extend the life of the coupling. Please, see: [URL]https://sdp-si.com/Rivin/art1.php[/URL] [URL]https://www.ksb.com/centrifugal-pump-lexicon/shaft-coupling/191984/[/URL] [/QUOTE]
Insert quotes…
Post reply
Forums
Engineering
Mechanical Engineering
Gearbox design-Is this design possible to make the output shaft thin?
Back
Top