Matlab GUIDE

  • MATLAB
  • Thread starter ranger
  • Start date
  • #1
ranger
Gold Member
1,676
1

Main Question or Discussion Point

Whenever we use GUIDE to create a GUI, GUIDE generates an m-file. Now,
is it possible for one to use this m-file generated by GUIDE to re-edit the GUI? I mean say I downloaded an m-file from the internet which has a GUI interface. Can I use GUIDE to edit the m-file and "tweak" the interface to my needs?

--thanks.
 

Answers and Replies

  • #2
ranger
Gold Member
1,676
1
I figured it out. If anyone cares, the command is guide(gcf); Where gcf means get current figure. Of course the figure you wish to edit should obviously be open when you run that command.
 
  • #3
J77
1,076
1
If the gui is saved as foo.fig -- you can edit it specifically using guide(foo)
 
Last edited:

Related Threads on Matlab GUIDE

  • Last Post
Replies
1
Views
751
Replies
6
Views
2K
  • Last Post
Replies
1
Views
1K
  • Last Post
Replies
1
Views
543
Replies
4
Views
2K
Replies
4
Views
793
Replies
1
Views
5K
  • Last Post
Replies
9
Views
3K
  • Last Post
Replies
6
Views
7K
Top