MrPickle said:
MrPickle said:Okay, this was my initial thought but I'm not sure how well it'll work.
A line for the original position and length and then one going from the start of that one to the end of the diving board after it's bent.
You could then work out the angle inbetween?
MrPickle said:
The purpose of measuring bendiness is to accurately determine the flexibility or stiffness of an object. This can be useful in various fields such as engineering, material science, and biomechanics.
There are various techniques for measuring bendiness, such as using a ruler or caliper to measure the deflection of an object under a certain load, or using specialized tools like a flexometer or bend tester. The choice of measurement technique will depend on the type of material and the desired level of accuracy.
The most commonly used unit for measuring bendiness is the degree of deflection, which is typically measured in degrees or radians. Other units such as inches, millimeters, or micrometers may also be used depending on the scale of the object being measured.
To ensure accurate measurements of bendiness, it is important to use appropriate measurement techniques and tools, calibrate instruments regularly, and take multiple measurements to account for any potential errors. It is also important to follow standardized testing procedures to ensure consistency and comparability of results.
Bendiness can be measured in most materials, as long as they have some degree of flexibility. However, the measurement techniques and units may vary depending on the material properties. For example, bendiness in metals may be measured in terms of yield strength, while bendiness in plastics may be measured in terms of modulus of elasticity.