Main Question or Discussion Point
I have made a new design i haven't seen anywhere on youtube or elsewhere. it might be a freak accident that i found hho resonance but I may have found it. I have build a generator with only 2 plates which yes i've seen that on youtube before but thats when people are just experimenting with it to see how it will work and its 2 tiny plates. I have 2 plates that are 2 feet by 2 feet bolted together with i believe a .064 gap don't remember for sure but its close to that. I have posted a video on youtube at http://www.youtube.com/reddevil2576 Now i made some changes to it before i made this video because I was going to seal it up and hook a pump up to it so i can force the bubbles out and keep the surface area up as much as I can. But I think I cut to much off of the washers on the outside increasing the surface area way to much. There almost a half circle now just enough of the hole left so the nylon bolts would hold them in place. Before I did that though when i hooked it up to the same battery in the video it hummed like a transformer on a telephone pole but no longer does that probably because of me changing the surface area so much I will post a video once I fix that though and see if I can show you guys the humming. Still makes a little noise but it ain't no hum like a transformer on a telephone pole when they hum. I think its impossible to wire plates in series in water and the equations i've seen they would have to be wired in series so I tried to solve that by using 2 big plates. It wouldn't be wired in series underwater it be connected everywhere wouldn't be series or parallel either I don't know what you would call it. Anyways take a look and let me know what you think. I'm not trying to get rich i'm trying to stick it to the man......lol...... youtube is about to go down for a bit i'm waiting for the video to upload now so if you read this right after I post it you might be able to check out the video but not for long. and this was the first video I put up didn't know it has to go through some process before you could see it so I don't know how long you will have to wait.