Recent content by ANSAN

  1. ANSAN

    Need the Permissible Stress (Shear & Bending) values of various materials

    Thankyou Lnewqban, I will check it. Thanks for your guidance...!
  2. ANSAN

    Need the Permissible Stress (Shear & Bending) values of various materials

    Hi all, i need Permissible stress (Shear & Bending) values of various materials that is used for shaft design, as like below. Is there any software or excel sheet. kindly let know.
  3. ANSAN

    Selecting gear teeth numbers for 300 kW helical gear pair

    Thanks a lot for your fine reply. Since iam learning the art of Gearbox, need some guidance in your feedback, 1. How you choose these - 3 Gear teeth pair? 18 : 65.03368034292713 ≈ 2*3*3 : 5*13 close ratio, no common factors = hunting tooth. since its 18:65, no even numbers, so no hunting gear...
  4. ANSAN

    Selecting gear teeth numbers for 300 kW helical gear pair

    Thanks for your feedback, just a DIY.
  5. ANSAN

    Selecting gear teeth numbers for 300 kW helical gear pair

    Thanks for your feedback and Guidance, more helpful.
  6. ANSAN

    Selecting gear teeth numbers for 300 kW helical gear pair

    Hai all, I need to get to know how a Gear pair teeth numbers are selected. Details : Power = 300KW, N1=2950, N2=816.5 , i=3.62, Helix angle = 35deg, Pressure angle = 20deg. I need to know how to select a Gear pair teeth for this input? Knowing a gear set should have common Module to transmit...
See more