Recent content by boudzmawed

hehe we can just open it here :)

plus it's a bit difficult to place the hex vertical on the exhaust pipe of the care don't u think ?

having the exhaust on tube side means huge pressure drop which means a back pressure. ur sure it wil work ?

hi every1 , I'm trying to do the concept of a turbosteamer that the bmw is workking on but I'm facing few problems : the flow rate of water will be 9 ml/s and of pressure 6 bars . based on htri xchanger program , the best design of my shell and tube heat xchanger will be of 22 cm diameter and...

I'm trying to do the concept of a turbosteamer that the bmw is workking on but I'm facing few problems : the flow rate of water will be 9 ml/s and of pressure 6 bars . based on htri xchanger program , the best design of my shell and tube heat xchanger will be of 22 cm diameter and 6.4 mm tube...

I'm trying to do the concept of a turbosteamer that the bmw is workking on but I'm facing few problems : the flow rate of water will be 9 ml/s and of pressure 6 bars . based on htri xchanger program , the best design of my shell and tube heat xchanger will be of 22 cm diameter and 6.4 mm tube...

My data is taken from the HTRI exchanger program , for a flow of water of 9 ml/s and diameter of tubes of 6.4 mm and tube length of 0.5 meters , and number of tubes of 215 tubes , the tube velocity is around 0.11 m/s . my question is , how to make that very low flow get equally distributed for...

fluid velocity is around 0.11 m/s , what do you by other design? can you help me in that ? so far i got no experience except in the normal round design of tubes , thank you

as u know in heat transfer , Q depends on cross section aread and delta T mean, yes i need to take around 26 kw heat , but since the maximum temp of hot fluid is 650 C , and i need to heat water to around 400 C , then delta T mean is small , that's why i need big cross area, based on...

guys, imagine a flow rate of 9 ml/s and of pressure 7 bars going out of a pump, this flow will look like a thread ( very thin line ) , and it enters directly to the shell and tube exchanger that has 250 tubes , how will this flow be distributed equally in the tubes ? i think i need a certain...

guys ,i'm working on this project for my senior project , the tempreture is high enough to generate steam , however I'm facing a problem : according to my design , the water flow rate is very low (0.54 l/min) and the pressure is up to 7 bars , so I'm finding it hard to allow water to be...