Recent content by can12345

What is the effect of air bubble in transmission line when measuring differential pressure by the using an electronic transducer? Purging is a must before measurement, however if we still have some bubble inside the transmission line or in front of transducer diaphragm, how it may effect to my...

Hi everyone; How I can define the minor loss coefficient(pressure loss) of a filter which has 60nm pore diameter?

Electrical sensor. Let's say transducer.

What is the effect of transmission line while measuring pressure value? I want to learn difference between big and small diameter of measurement line (transmission line).

http://ocw.metu.edu.tr/pluginfile.php/1869/mod_resource/content/0/AE547/AE547_7_unsteadypressure.pdf Here you can see they also say as '' The rate at which this will occur will also depend on the pressure loss characteristics of the connecting connecting line, wall pressure pressure tapping...

How I can determine this velocity? Can you give equation or help please?

The exactly question is actually to check whether pressure loses are negligible in unsteady (turbulent, oscilation) conditions.

I actually try to define the pressure loss through diaphragm. When turbulent flow is acting to pressure diaphragm, there is two situation. First of all the diaphragm is always under oscillation. This is the reason why I want to separate the problem into 2 section. First of all when fluid is...

Homework Statement I would like to define pressure loses through transmission line to the transducer. In transmission line I have a reducing union, filter and L pipe. How I can find this differences? In case of frequency my reducing union reduce pipe diameter 6 mm to 3 mm how i can determine...

Homework Statement Is there any difference if I measure static pressure value from the down side of the pipe or up side of the pipe? I am getting an error just small as 300 pascal when I do zero measurement. Here I draw the system also. The diameter of pipe is 10 cm. What could be the possible...

They are all mixed there ;) maybe try to open an homework page only for mechanical engineering ;)

of averaging of a specific task to get some impression. Or some ways to determine time for quasi steady pressure time with some experiment so on.

Strain gauge

< Mentor Note -- thread moved to HH from the technical engineering forums, so no HH Template is shown >[/color] Hello What are the possible errors when measuring pressure value by the using a transducer? And how we can find the amount of errors?

Thank you so much. Do you know any sources or implementation for it? Your answer is exactly what i was looking for also.