Recent content by carveranderson

@OmCheeto , @jrmichler , if the MIC6 3/8" thick plate I'm using on the bottom is sufficient (again not sure what formula for that), could I maybe use that on the top as well instead of poly, and get a small sight glass insert? I've got a small camera with it's own light source I could mount...

@OmCheeto , thanks! In the video, he mentions using engineering formulas to figure out what thicknesses needed and he was expecting much higher pressures, implying this was overkill. I can't seem to figure out what formulas are needed to determine what thickness you'd need of polycarbonate (or...

The tube I'm using is 6" long, 6" diameter and .5" wall thickness and made of 6061 aluminum. The bottom is a 6" diameter, 3/8" thick MIC6 Cast Aluminum Disc. The top I TRIED is a 6" diameter, 1/2" thick clear polycarbonate disc. Both top and bottom are bolted on with a 1/16" buna-n o-ring and...